Tools needed:- 3mm Allen key or hex driver bit- 17mm crescent wrench or deep socket- Needle-nose pliersParts needed:Vacuum Breaker Rebuild Kit1. Set aside the cup warming tray, then remove the top panel of the machine. Unscrew the four Allen head...
Tools Needed:- 21mm crescent wrench or adjustable wrench- Pick or small prying implement- PTFE tape aka plumber's tape OR food safe thread sealant- New plumbing seat (if needed)1. Open the valve all the way. 2. Using a crescent wrench or...
Tools Needed:- Adjustable wrench- Shop towel- Pick or small prying implement- New gasket, ECM/Profitec part P60151. Remove the steam/hot water valve assembly.2. Use a large adjustable wrench to remove the wand arm ball joint nut. Drape a towel...
Tools Needed: - 2.5mm allen key - 3mm allen key First, you’ll need to remove your panels. There are two small SSRs on the standing panel next to the water tank, fastened by one screw each. The brew boiler SSR is located closest to the front of the...
Tools Needed:- Fingies1. With the machine powered OFF, press and hold the "+" button on the PID control unit. 2. Keep pressing and holding as you power the machine on.3. Keep pressing and holding until the PID initializes. You may see a three...
Tools Needed: 3mm Allen Key Towels NOTE: The machine should be unplugged and cool to the touch before you begin. 1. Remove the rear panel of your Pro 600 2. Locate the bulb filter located under the water reservoir holder. 3. Remove the bulb filter...