In this article you will find the proper spot for the shot timer wire. 1. Remove the panels of the M58. 2. Remove the motor capacitor by loosening/removing this nut and sliding the capacitor out of place. 3. Trace the purple wire from the black...
Water tank not full: If you are using the machine in water tank mode, you may just be out of water. Refill the tank and see if the PID turns on.If you are using the machine in plumbed in mode: Verify that the switch in the back of the machine is...
Below are photos for checking the power inlet wire on the PID and photos for checking if the water tank magnet is not interacting with the magnet switch. Before attempting to remove the panels from the machine and check the PID, we recommend...
Coffee Boiler Not Heating: If the coffee boiler isn’t heating you should follow along with these steps to see what may be causing the issue. Is the PID on? If the PID is not on follow along with our guide here on PID troubleshooting. Is the red...
Water tank not full: If you are using the machine in water tank mode, you may just be out of water. Refill the tank and see if the PID turns on.If you are using the machine in plumbed in mode: Verify that the low water alarm switch is in the...
If you are hearing beeping, seeing flashing lights, or no PID display, your machine is not registering a water source. Here are a few reasons why: 1. Water tank not full: If you are using the machine in water tank mode, you may just be out of...
1. With the machine plugged in, but powered off. Press and hold the right PID button.2. Continue pressing and holding the right PID button as you flip the main power switch to power the machine on.3. Keep pressing the right PID button as the...
Tools Needed:- Phillips head screwdriver- 12mm deep socket and ratcheting wrench - Ratcheting wrench extension (optional)NOTE: The machine should be off and cool to the touch when you begin. Open the machine's hot water valve and direct the wand...