LUCCA M58 V2: Water Light is FlashingUpdated 6 months ago

If you are hearing beeping, seeing flashing lights, or no PID display, your machine is not registering a water source. Here are a few reasons why:

1. Water tank not full: If you are using the machine in water tank mode, you may just be out of water. Refill the tank and see if the PID turns on, lights and beeping stop.

2. If you are using the machine in Reservoir Mode: Verify that the valve on the bottom of the machine is set to Reservoir Mode (I).

Also, ensure that the low water alarm is on (O).

3. If you are using your machine in Plumbed-In Mode: Ensure that the valve is turned in the opposite direction and the low water alarm is bypassed (I). 

4. If you are in Reservoir Mode, and there is water in your reservoir tank: Take a look at the bottom of your water reservoir, at your Outlet Valve. This is where your water sensor is located. 

Make sure there are no obstructions to the outlet assembly, and that the metal valve piston can be pressed in and returns to the pictured position. If either of these appear to be obstructed, remove the assembly by removing all four screws.
Once out, pry off the white cap of the outlet assembly.
Remove the inner float component, and clean out any debris found around the metal piston or the rest of the assembly.


It is possible the sensor has gone bad. If there are obvious mechanical issues with this component, or un-obvious mechanical issues reaching beyond the scope of this article, please reach out to us at [email protected] for further assistance in ordering and replacing parts.