Tools Needed: 3mm Allen Wrench This machine is heavy; a helper may be required to remove the panels. 1. Unscrew the lever and set aside.2. Remove the four screws holding the top panel in place. 3. Tip the machine backwards to access and remove the...
What you'll need: - 6mm allen key First, you'll need to drain the boiler by allowing the machine to fully heat, turning the machine off, and opening the hot water arm until the built-up pressure pushes all water from the boiler. Allow the machine...
You'll Need: - 22mm Wrench Using the 22 mm wrench, loosen the nut fitting fastening the steam arm to the valve assembly. Remove the wand assembly from the valve, careful not to lose the spring inside. Remove the tip of the steam wand, and slide...
What you'll need: - 13mm wrench - 14mm wrench (two of these) First you'll need to remove the panels from your machine. On the right side of the machine, you'll find the pressure gauge. Using the 13mm wrench on the capillary tube's nut and a 14 mm...
Tools needed:- 2.5 mm Allen key- 17mm crescent wrench or deep socket- Pliers Parts needed: Vacuum Breaker Rebuild Kit or Complete Vacuum Breaker NOTE: Start with the machine unplugged and cool to the touch.1. Start by removing the panels from the...