Profitec Pro 800: Replacing the Boiler ElementUpdated 5 months ago

What you'll need: 

- 6mm allen key

First, you'll need to drain the boiler by allowing the machine to fully heat, turning the machine off, and opening the hot water arm until the built-up pressure pushes all water from the boiler. Allow the machine to cool, and remove the panels from your machine. You can access the boiler element from the left side of the machine.

Before going further, remove the wired connections from the element legs.

Using your 6mm allen key (or bit), remove the three nuts fastening the element to the boiler.

Pull the element from the boiler.

Replace the element and gasket with new parts following these steps in reverse order. If you have any questions, contact us at [email protected].