Slayer

Slayer: Checking Actuator Sensors

Before doing this we recommend unplugging the machine and allowing it to cool off. Tools required: phillips screw driver magnet

Slayer: Relief Valve Leak

Tools required: phillips screwdriver If the brass expansion valve is leaking you can try tightening it using a pick. If you can't stop the leak from the expansion valve or the black hose is leaking please contact us for further instructions.

Slayer: Removing Pressure Transducer

Tools Needed: Adjustable wrench Wire cutters/scissors Small zip tie 1. Lift off the top of the machine. The pressure transducer is located on the back wall of the machine on the left side. 2. Remove the transducer by taking off the small nut...

Slayer: Checking Power To Board And Screen

Before doing this we recommend unplugging your machine and allowing it to cool down fully. Tools required: phillips screwdriver multimeter(if computer is unresponsive) If the screen does not turn on and the board illuminates then the ribbon cable...

Slayer: Installation Guide

Slayer Espresso Single Group Installation Requirements

Slayer: Expansion Valve

Expansion valves also wear over time and will eventually need to be replaced. Tools required: Phillips screwdriver angled / 90 degree pick

Slayer: Pump Pressure Loss

Group Head Flow Grab a cup that you can get a measurement with, what you want to check is the flow of the group head when the machine is in full brew(actuator to the left) mode. You are looking for about 4 ounces in 10 seconds through the group...

Slayer: Replacing Gear Pump

If your Slayer 1-Group gear pump needs to be replaced we have a video here showing how to do that (password is "prebrew"). It is the fifth video on this page entitled "One Group Pump Replacement". Before attempting this we recommend verifying the...