Tools Needed:3mm allen key2 Adjustable wrenches1. Remove the panels of the machine: Pro 500 Panel Removal2. Remove the 2 screws holding the water reservoir slot in place and move it to the side.3. Remove the hose from the expansion valve and the...
Tools Needed: 2.5mm Allen Wrench 3mm Allen Wrench Flathead Screwdriver Remove the panels of the machine, instructions for panel removal can be found here: Pro 500 Panel Removal. The expansion valve is found at the back of the machine. Use a...
Tools Needed: 1.5mm Allen Wrench 2.5mm Allen Wrench 3mm Allen Wrench Flathead Screwdriver 1. Remove the panels of the machine, step by step instructions can be found here: Pro 500 Panel Removal 2. You will find the expansion valve in the back of...
You can purchase a vibratory pump here. Tools Needed: 2.5mm Allen Wrench 3mm Allen Wrench 10mm Open-ended Wrench 12mm Open-ended Wrench 13mm Open-ended Wrench 1. You will need to remove the panels of your machine, you can find instructions on how...
Water Tank Connector Instructions
Tools needed: 2.5mm + 3mm allen wrench, small phillips screwdriver, small flathead screwdriver While it's not necessary, you may opt to remove the panels of the machine so you can get a better look at what you're doing. 1. Turn the machine off,...
You'll need: - pliers - flat blade or flat screw driver First, you'll need to Remove the Panels from your machine Locate the lights on the inside of the front panel, and remove the wiring from the back of the appropriate light. It may be helpful...
Tools Needed:- 21mm crescent wrench or large adjustable wrench- Pick or similar implementReplacement Steam/Hot Water Valve GasketNOTE: Although only the steam side of this machine is shown, these instructions are exactly the same for both the...
Tools Needed:- Small flat bladed screw driver(or similar implement)1. Use the small screwdriver to carefully pry the center cap from the knob.2. Use the small screwdriver gently pry the E-clip retaining clip from the end of the valve spindle. Be...
Tools Needed:- 2.5mm Allen wrench or hex driver- 3.0mm Allen wrench or hex driver- Channel lock pliers or similar- Masking tape- Replacement power switch 1. Start by removing the panels from the machine.2. Identify the retaining collar on the...