Eureka Atom: Inspecting Motor ConnectionsUpdated 6 months ago

Before doing this be sure to unplug machine.

Tools required:

• Phillips screwdriver

1. Remove the screws holding the bottom panel in place.

2. Make sure the capacitor connections are clean and securely installed.

3. Verify that the main power connections are cleaned and securely installed.

4. Make sure that the main board connections are clean and securely installed.

5. Make sure that the control board and motor capacitor connections are attached as shown below:
NOTE: If you need to replace the motor capacitor, simply unplug the red and blue wires, then slide the capacitor out of the zip tie and replace it with the new capacitor. The capacitor connections are non-directional, so the red and blue wires can be reattached in any order.