Tools Needed:- 2.5mm hex driver or Allen key- 3mm hex driver or Allen key1. Remove the cup warming tray and reservoir tank.2. Remove the six 2.5mm Allen screws holding the top panel in place, then remove the top panel.3. Carefully set the machine...
1) Start with your machine unplugged (coiled power cord), drained, and fully cooled down. 2) Insert the flat foam block on the bottom of the box and gently rest your machine onto it/ 3) Carefully arrange the flexible foam backing around the...
Tools Needed:- Small pitcher-Large pitcher1) Begin with your machine fully heated. 2) Remove the reservoir from your machine. 3) Lift the brew lever and allow water to flow out of the group head into a pitcher. 4) Open your hot water wand and...
Tools Required: 3mm Allen key 13mm wrench 12mm wrench Thin flat blade Teflon Tape New Pump 1. You'll begin by unplugging the machine, letting it cool and removing the panels 2. Remove the two connectors from the vibratory pump 3. Remove the...
Tools Needed:- Portafilter with back flush disc installed- Flat-bladed screwdriverThe basics:- Start with the machine fully heated. - Turning the adjustment cap in (clockwise) raises the pressure at the group head.- Backing the adjustment cap out...
Tools Needed:- 2.5mm Allen key or hex driver- 3mm Allen key or hex driver- Flat-bladed screwdriver- Small pick or bent paperclip.Parts Needed:Replacement expansion valve seat1. Remove the panels from the machine.2. Identify the expansion valve on...
Tools needed: - 2.5 mm allen wrench - 3 mm allen wrench 1) Remove the panels 2) Unscrew the front-facing switch nut 3) Carefully remove the power switch to the side of the machine 4) Carefully transfer over the four wire terminals to the new...