Quick Mill Andreja Premium - Cleaning or Replacing Steam/Hot Water Arm GasketUpdated 6 months ago

The machine will need to be off and cooled down before doing this procedure.

Tools Needed:

• Flat head screwdriver
• Adjustable wrench
• Pick
• A new gasket, found here.

1. Remove the silver cap from the front of the knob, and pop off the small e-clip on the end of the post pointed out here.

2. Unthread the knob all the way off, and then use the adjustable wrench to unthread the rear part of the knob assembly.

3. From here you can clean off the gasket, replace it, or even just flip the gasket over to create a new flat side for the valve to seal with.