Eureka Oro Mignon Single Dose Espresso Grinder: Setup GuideUpdated 5 months ago
This quick start guide will walk you through setting up your grinder. Check the product page and the manufacturer's brochure for a list of included accessories, details, and specs. See the User Manual for information on operating the grinder and for additional resources.
Step one: Out of the box and onto the counter
- Remove the grinder from its box and place it on a solid-level surface.
- Inspect the grinder for any damage. If you notice any, contact us immediately.
- Place the hopper into the grinder and if you wish to use it, attach the bellow and lid of your choice.
- Set the dosing cup onto the magnetic wooden base.
- Ensure the rotating metal tab is closed before adding coffee to the hopper.
Step two: Operating your grinder
- Plug in your grinder.
- The activation switch, located on the rear right side of the chassis, turns the grinder motor on and off.
- With the metal tab closed, activate the grinder using the switch, then add coffee beans to the hopper.
- With coffee in the hopper and the motor running, open the tab, allowing the coffee to grind through into the dosing cup or vessel of your choice.
- Close the metal tab and use the blow-up hopper to push any remaining grinders through the burr chamber.
- Once ground, set the dosing cup aside and use the bellow to clean the remaining coffee grounds out of the chute while the grinder runs.
- Turn off the grinder using the activation switch.
Step three: Dialing in your grind
- If you elected for Clive to dial in your grinder, we recommend pulling a shot before making a grind adjustment.
- To adjust the grind size, move the continuous adjustment knob clockwise for a finer grind or counterclockwise for a coarser grind.
Additional Resources:
If you need help dialing in your equipment or pulling shots, check out the articles below or contact our coffee experts and technicians.